Headlamp Bulb Replacement

Dip (Low) Beam Headlamp replacement (cont)



With the bulb remove notice the orientation of the locating holes and flat face. The corresponding locating points can be seen on the bulb.

Engine Cover

Wearing Latex gloves remove the new bulb from it's packaging and fit it into the headlamp assembly, referring to the above, ensure that the new bulb is correctly orientated, then replace the spring clips that retain it.

End of skewer



Refit the rear plastic cover and press the inner retaining back into position. The outer clip is much harder to refit, this is made easier using the meat skewer, slip the open part of the circular end of the skewer over the rear cover clip. Pull on the skewer and clip it back over the cover.

First Cover Clip



Valid XHTML 1.1